Reply to thread

Not an expert either. But I have a lot of experience modeling. Speaking from experience the Harbor Freight airbrushes are ok for painting if your just trying to get an even coat but any kind of details forget it. I have always used Badger airbrushes (except for my cheap harbor freight one). As far as compressors go I use my craftsman 25 Gal compressor that I also use for automotive work but for airbrushing I attach a smaller secondary in-line regulator so I can fine tune the air pressure.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top