Reply to thread

add about a gallon of water and a teaspoon of black water based acrylic paint in bucket, mix well,

put the whole belt in and let it soak. let it fully dry and repeat if necessary....my belt came out just like the original


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top