Reply to thread

From my limited experience a two piece mould can be tricky to line up, especially if the join runs through detailed areas which makes cleaning up time consuming and tricky. The best thing is probably a skin mould, which can be backed up by a two piece plaster or fibre glass jacket. If your're in the uk i would contact Alec Tiranti Ltd they can supply you with all the correct materials and they sell inexpensive booklets explaining all the processes ( i'm using their T 20 silicone which is very tear resistant, ideal for skin moulds) Cheers.....TF


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top