Reply to thread

Message

OK...long awaited update...lots of stuff done, just haven't had the chance to post up...

Helmet resin jellied
[ATTACH=full]134846[/ATTACH]

Shriekhawk resin jellied
[ATTACH=full]134847[/ATTACH]

and sanded and set up for mockup (note the no-neck space)
[ATTACH=full]134848[/ATTACH]

Started formwork and glassing on lower canister of rebreather
[ATTACH=full]134849[/ATTACH]

Then the helmet oxygen hose was installed
[ATTACH=full]134850[/ATTACH]

And the shknee guards were shaped, drilled for mounting to boots and knees secured to shinguards with metal plating
[ATTACH=full]134851[/ATTACH]

Tomorrow's forecast calls for shknee guard wireform and initial glassing, beginning gauntlet construction, cleaning of the upper armor for fitting to set up for chestplate alignment & design, as well as chest plate design and initial wireform (possible glassing)

<blockquote data-quote="AdennGraTuar" data-source="post: 381302" data-attributes="member: 7049">OK...long awaited update...lots of stuff done, just haven&#039;t had the chance to post up...Helmet resin jellied[ATTACH=full]134846[/ATTACH]Shriekhawk resin jellied[ATTACH=full]134847[/ATTACH]and sanded and set up for mockup (note the no-neck space)[ATTACH=full]134848[/ATTACH]Started formwork and glassing on lower canister of rebreather[ATTACH=full]134849[/ATTACH]Then the helmet oxygen hose was installed [ATTACH=full]134850[/ATTACH] And the shknee guards were shaped, drilled for mounting to boots and knees secured to shinguards with metal plating[ATTACH=full]134851[/ATTACH]Tomorrow&#039;s forecast calls for shknee guard wireform and initial glassing, beginning gauntlet construction, cleaning of the upper armor for fitting to set up for chestplate alignment &amp; design, as well as chest plate design and initial wireform (possible glassing)</blockquote>

[QUOTE="AdennGraTuar, post: 381302, member: 7049"] OK...long awaited update...lots of stuff done, just haven't had the chance to post up... Helmet resin jellied [ATTACH=full]134846[/ATTACH] Shriekhawk resin jellied [ATTACH=full]134847[/ATTACH] and sanded and set up for mockup (note the no-neck space) [ATTACH=full]134848[/ATTACH] Started formwork and glassing on lower canister of rebreather [ATTACH=full]134849[/ATTACH] Then the helmet oxygen hose was installed [ATTACH=full]134850[/ATTACH] And the shknee guards were shaped, drilled for mounting to boots and knees secured to shinguards with metal plating [ATTACH=full]134851[/ATTACH] Tomorrow's forecast calls for shknee guard wireform and initial glassing, beginning gauntlet construction, cleaning of the upper armor for fitting to set up for chestplate alignment & design, as well as chest plate design and initial wireform (possible glassing) [/QUOTE]

This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification