Reply to thread

Way back when Bill was still making Asok helmets I bought a B grade helmet from him.  The resin had not evened out and there were thin spots.  I was able to apply fiberglass with no problems ...even with a thin wall of resin.


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top