Reply to thread

Hi everyone!


Random question here, but has anyone tried adding dents to plastic or 3D printed (in this case, PLA) parts?


I 3D printed the knee armor pieces thanks to [USER=4963]RafalFett[/USER], but I need to add some ROTJ era dents to them.


I had a scrap gauntlet piece that I used to test out some denting methods.  I ended up heating the piece with a heat gun and pressed the end of a ball-peen hammer into it:


[ATTACH=full]214294[/ATTACH]


I then sanded the pieces to see how the surrounding areas were affected by the heat.  Not too bad, but you can definitely see the areas around the 2 circled dents got a little warped.


I might try again with a smaller ball-peen hammer, and maybe taping off the other areas with some foil to hopefully isolate the heat.


Any ideas anyone?


Thanks!


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top