Reply to thread

I know it was mentioned in another thread, but what about a two piece slimmer earcap where the triangular piece at the bottom tucks under the base?



And what about molding an MQ-1 into the keyslot area?


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top