Reply to thread

Hi,

I'm looking to print a "comfy Boba" or repainted Boba, and I found these files from Galactic Armory. I'm not super keen on all the nuances of detail and differences so I was wondering if someone had already seen these files and examined them for accuracy? I'm also looking at the free RafalFett files but I like these since they include gauntlets and damage on the breastplate.


For the helmet I think I'm actually going to go with this one. The pieces seem very nice and at a glance it looks accurate to me, but wondering if someone could advise on that as well.


I'm not necessarily looking to troop but I would like to try and be as accurate as possible. Thank you!


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top