Reply to thread

I need the dimension of the gun from the tip of the barrel to the end of the stalk (ROTJ Version).


Why do you ask?


I have found some PVC material that is used for exterior cornice, etc.  I plan on using it to construct a complete PVC blaster (minus the stalk, I have a perfect piece of mahogany for that.)  I have the rough dimensions but I want to scale them correctly so I can get the ball rolling on this.


Any help is appreciated.

Thanks

Darren


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top