Reply to thread

I'm in the process of making my lid, and I was looking up dimensions/measurements etc. Something very odd made itself apparent to me: it looks as if his mandibles are asymmetrical? One is slightly higher than the other. Or is it? Arrgh! TBH, I may just do them symmetrical otherwise it'll drive me crazy! I was just hoping one of you far more knowledgeable lot could shed some light!


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top