Reply to thread

Message

Thanks Squirrlie, the tongue was made by making a plasticene/modeling clay model, and then covering it with several layers of latex rubber. When the clay is removed, you have a hollow, balloon-like appendage. I couldn't use my own tongue anyway, for this Bossk has built up shoulders, and I must peer out of his mouth, with my own mouth down in his neck. I did this to make him stand about 6'8", and so I could use realistic glass taxidermy eyes, instead of just looking through mask holes where the eyes should be.

[QUOTE="Bossk, post: 290674, member: 4387"] Thanks Squirrlie, the tongue was made by making a plasticene/modeling clay model, and then covering it with several layers of latex rubber. When the clay is removed, you have a hollow, balloon-like appendage. I couldn't use my own tongue anyway, for this Bossk has built up shoulders, and I must peer out of his mouth, with my own mouth down in his neck. I did this to make him stand about 6'8", and so I could use realistic glass taxidermy eyes, instead of just looking through mask holes where the eyes should be. [/QUOTE]

This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification