Reply to thread

Unfortunately I do not have access to a workshop either, so making it myself won't be an option. I am leaning towards Woodchuck - I have seen plenty of his work. I'm thinking of approaching him to make the K-11 and the long arms for me as well.




I did also consider 3D printing. The problem is that I found that not many guys out there do it cheaply. Id also be a bit worried about its durability over the long term. I like your suggestions though.


Im going to cover off in much more detail on the weapons and give them a break down similar to my first post. After that I'll do a breakdown of my parts list which will state who I have got parts from and who I intend to ask for parts.


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top