Reply to thread

Quick update - only had a few minutes today to work on this  - so I started the bridge of the nose, now I can cast and sand it, as the rest of the head will be scaled and based off this one part... Because all of the cuts are straight, I am using a blade more than tools, but I have to be honest, trying to sculpt the "damage" in there, like the dings, nicks and scrapes  -  it's tough...

[ATTACH=full]114501[/ATTACH]


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top