Reply to thread

Yeah, I have a dremel, but the drawing I found (if I'm reading it correctly) has 5mm holes that "touch" to make a 10mm oblong hole. I thought about trying to spread them a little further and that may be what I have to do. So do you suggest trying to drill them with a mill or so gap and just dremel it out?


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top