Reply to thread

I saw some 3d printed objects at my state fair a few years ago. One of those objects was a small, fully functional, differential gearbox - printed in ONE piece! It was phenomenal. However, at present time it's only practical for rapid prototyping.


This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top