Reply to thread

Head Shot has great products. I have one of their buckets. I found one model on Thingyverse and started the printing process myself a while back before I found out about the Mando Merc sizing requirements. Still the files had the thing cut into 30 pieces for the smaller sized print beds and a small scaled complete bucket. Has me inspired again well done on your efforts


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top