Reply to thread

It was around 3/4 of a spool for everything... not sure of the entire length... that should be in the slicer files. I'll take a look when I'm back from vacation :-)


- - - Updated - - -


Using a Lulzbot Taz printer... by no means an expert at this yet, but starting to figure out different ways to get stuff done :-) Thanks for the tip! Haven't had a chance to touch this project in a week so anxious to get back at it!


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top