Reply to thread

You shouldn't have that kind of trouble printing out a curved surface, what type of printer are you using?  Alsoyou try printing it using supports and see if that helps, I've found that non-flat surfaces sometimes come out better when you add supports.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top