Reply to thread

Ah...yes I did, but not it than way.  The earcap with the stalk is the tricky one.  Here are some pics of the first try of the left earcap...I printed it upside down since that was the flat surface, but the angle was a little rough.  I will try slicing it along the lateral plane...that should work better...thanks for the idea!


[ATTACH]45948[/ATTACH][ATTACH]45949[/ATTACH][ATTACH]45950[/ATTACH]


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top