Reply to thread

Finally finished!  The helmet had to be sliced off in the 3D file as mentioned above, so it needs to be reattached (it sits low in the pics)  But all in all a great skeleton!  Next is the fiberglass/bondo stage.  Also tried printing the earcaps but they are not flat on the bottom and do not print well.  Had one that might be passable, and would have been fine if they had been printed with the helmet, but it would not have fit on the bed with them on :(  I'll probably make some or order some resin ones.  Anyway...here is the final print...


[ATTACH]45409[/ATTACH][ATTACH]45413[/ATTACH][ATTACH]45411[/ATTACH][ATTACH]45410[/ATTACH][ATTACH]45412[/ATTACH]


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top