Reply to thread

But how much are the printers for said materials?  That's the limiting aspect I think.


Low temp metals are fun, aren't they?  My husband and I look forward to finally getting a bit of space away from the city to do more fun stuff.  We have a nice kiln in the garage just wasted as we can't use it here.


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top