Reply to thread

You're semi correct.  I can print with filaments that contain alloy, bronze and magnetic iron...which can be processed just like normal.  The alloy and bronze can buffed and polished, and the iron can rust.  And in all actually, they're not more than about $50 a spool.


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top