Reply to thread

Hey amigos!,


Ok got a couple of bit printed on high res so sanded to uber smooth, then primed, silver base, black, then weathered, trying to achieve the look in the gallery but very difficult!

[ATTACH]44496[/ATTACH][ATTACH]44497[/ATTACH][ATTACH]44498[/ATTACH][ATTACH]44499[/ATTACH]  so that piece is complete just needs a lacquer then on to the next [ATTACH]44500[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top