Reply to thread

Hello all


I’ve been slowly working on my ROTJ build starting with shin tools. I was wondering if those in the community that do 3D printing have any finishing tips to share?


My best finished piece which is ready for painting took me roughly 12 or more hours to get to this point. The close up picture was part way through the process. The full length shot is ready to paint. Didn’t want it too smooth or the paint won’t stick. :)


Not afraid of hard work (I have drawn blood already) but was hoping others out there have thoughts or suggestions to share.


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top