Reply to thread

Update on my progress:  I've gone a long way with this.  Finished printing each side and gluing the parts together.  It's rough, but I'm making a mold of this.  Pieces are glued with Acrylic glue and I filled it with Gold Bondo.  Which sticks a little better to plastic.  It sticks so well I've used it to repair cracking.


[ATTACH]68783[/ATTACH]


To correct more layer shifting I had to make some cuts with the Dremel.  PLA has a low glass point so it's never pretty to cut this stuff.

[ATTACH]68784[/ATTACH]


Bits and pieces that need to be re-modeled.  I've found a few issues as I looked at the fitting of these components.  The stock for the range finder is incorrect so I need to work that one out.  And I need to add the range finder stock connector to the helmet instead of the cap that I have modeled now. 


[ATTACH]68785[/ATTACH]


[ATTACH]68786[/ATTACH]


This thread is more than 8 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top