Reply to thread

Message

Well here is something that I have been wanting to do since I did the original Jango templates. Now the next step is to flatten the 3D model into usable templates.

So take a look and post your feedback. I still need to do some surface smoothing.

Alan

Updated 10/30/2013 Added flat patterns. These are a bit more complex than Boba's and are more like a Pep file.
http://home.comcast.net/~wizardofflight/Jango_Cod.pdf

[ATTACH=full]39576[/ATTACH]

[QUOTE="wizardofflight, post: 370419, member: 576"] Well here is something that I have been wanting to do since I did the original Jango templates. Now the next step is to flatten the 3D model into usable templates. So take a look and post your feedback. I still need to do some surface smoothing. Alan Updated 10/30/2013 Added flat patterns. These are a bit more complex than Boba's and are more like a Pep file. [url]http://home.comcast.net/~wizardofflight/Jango_Cod.pdf[/url] [ATTACH=full]39576[/ATTACH] [/QUOTE]

This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification