Reply to thread

First Post updated.


I sized the figure to the real pluce 40 measurements. However, I know Aprilstorm said it was a bit large but to get the real measurements I had to actually scale the model up a bit so I'm not sure what's up with that. The new OBJ and STL file are available but until I'm absolutely sure it's going to work UPLOAD AND PRINT AT YOUR OWN RISK!


I also kept the grooves in since I saw that it was on the in movie picture as well. Hopefully I'll get pics up later.


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top