Reply to thread

No it's OK. I made this thread to give back to fellow Fett heads! Sometimes it takes more than 1 to make things happen. Hope your print goes well.


Blaster update: I'm consulting with a buddy of mine tomorrow to further optimize the sidearm size and format for printing tomorrow. Hopefully I will update the obj file then!


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top