Reply to thread

Awesome. I was just thinking about doing something like this for the Nemrod holster yesterday. I just read in Popular Mechanics that there is a website that will convert photos of an object into 3d files for printing. You take 20 photos at different angles, upload them and then use the program to clean up and edit. It's supposed to be free but I haven't checked it out yet. You look like you're off to a great start though. Are you going to make these files available to everyone?


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top