Reply to thread

Hey for all the greeblies I did a mold (some are from an unknown maker and some are 3D printed) I 3D model the cape seal, hand plates and ovaries. The moon crest I got the files from 3Demon


The gauntlets, chest armor and helmet I’m getting from MonCal. I’m still missing the Shin and ankle armor which I’m going to order from MonCal as well. I’m 3D modeling the Toe armor which I hope to finish soon


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top