Reply to thread

I wish I could go out and buy a jogsaw, even a cheap one, what I ended up doing was putting the rest of the wooden part INTO the stock, tomorrow I'll buy some opf that foam stuff and fill it up, that should also fix that in there hard enough to hold it then I'll just rivet it onto the blaster and I'll be done


This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top