Fettronics
Active Hunter
I had a question about this, so I thought I would send out a post to see what others thought.
In one of the older posts, slot dimensions for the TK409 boards were
Length of slots: 48mm
Height of top slot: 5mm
Distance between slots: 7mm
Height of bottom slot: 9mm
I think the Shackman and TK409 boards use the .3 inch segment displays. My boards use the .39 inch segments displays.
My board dimensions are
Length of slots: 50mm
Height of top slot: 5mm
Distance between slots: 5 to 9mm (normally 8mm)
Height of bottom slot: 10mm
The screen used version cut the last character in half, so getting the slots cut at the 48mm wide dimensions would be screen accurate.
My question is, what dimensions are the armor makers using? Has anyone who purchased a Fettronics board had trouble with the slot sizes?
Jon
www.Fettronics.com
In one of the older posts, slot dimensions for the TK409 boards were
Length of slots: 48mm
Height of top slot: 5mm
Distance between slots: 7mm
Height of bottom slot: 9mm
I think the Shackman and TK409 boards use the .3 inch segment displays. My boards use the .39 inch segments displays.
My board dimensions are
Length of slots: 50mm
Height of top slot: 5mm
Distance between slots: 5 to 9mm (normally 8mm)
Height of bottom slot: 10mm
The screen used version cut the last character in half, so getting the slots cut at the 48mm wide dimensions would be screen accurate.
My question is, what dimensions are the armor makers using? Has anyone who purchased a Fettronics board had trouble with the slot sizes?
Jon
www.Fettronics.com