TD2252,
I'm having a little problem. I have everything wired up but only one monterary switch works and when I press the switch it moves the servo when I let go of the switch the servo returns back to the starting point. Any thoughts on what I did wrong?
Great tutorial!!!!!!
Thanx for all of your hard work.....
talented!!!!
OK, I can NOT apologize for this any more than I possibly am. I am a new member, but my account with TDH has been in effect for a few months now. I have a question. Why am I so restricted to what I can and can't access...
Thats the kiddy, quite big at 2.5" square. They must do a single controller version which would come in abit smaller though. I havent got my Boba yet so dont know what the inside on the guantlets look like. Would something like that mount in a guantlet do you think?
Thanks for the compliment! Yes, you can do something along the lines of hard wiring the entire system or connect the switch directly to your helmet. I actually have a dual servo driver that I was tinkering with and I believe that attaching your RF servo will work great with it. The best thing about it is that you don't have to modify the servo, all you have to do is connect it to the board and give it a power supply and your done! Here is a pic of it. It has two potentiometer knobs, one for each servo and the servo will actuate as fast or as slow as you can turn the knobs. This is available HERE. Hope this helps a bit!