Shabazz Jenkins
Hunter
OK, I just got my BooBoo Fett jetpack harness yesterday, and I installed got the bottom hooks installed on the jetpack and went to get everything together last night. I have WickedBeard armor, including backplate.
When I put the armor over the harness, my backplate sits too far out on my back. It bows out over the curved tube at the top of the harness, and bends just above, where the shoulders attach to the collar armor. It leaves a big bulging bow at the back of the arms that you can see into and see the harness - even with the jetpack attached.
Anyone else run into this issue? It is almost as if I need to beef up the backplate where it is bending, so that it pulls flush with my back all the way up and hold tight against the harness. Anyone have any bright ideas?
I can take pics of what is happening, if it helps. But basically it is just that the armor is pulling the harness up snug to my back, but is rather sitting against the harness and folding in toward my shoulders at the top, just above the top of the harness.
When I put the armor over the harness, my backplate sits too far out on my back. It bows out over the curved tube at the top of the harness, and bends just above, where the shoulders attach to the collar armor. It leaves a big bulging bow at the back of the arms that you can see into and see the harness - even with the jetpack attached.
Anyone else run into this issue? It is almost as if I need to beef up the backplate where it is bending, so that it pulls flush with my back all the way up and hold tight against the harness. Anyone have any bright ideas?
I can take pics of what is happening, if it helps. But basically it is just that the armor is pulling the harness up snug to my back, but is rather sitting against the harness and folding in toward my shoulders at the top, just above the top of the harness.