Just updated the first post with the Red Face & Keyhole, Back Plates and Cheek color separation files. In a few days I will do the Dome color separation files. Then... We'll see.
Just updated the first post with the Red Face & Keyhole, Back Plates and Cheek color separation files. In a few days I will do the Dome color separation files. Then... We'll see.
Sadly I don't have a MR or MR based helmet, but I think it's slightly bigger then the original helmet(s). I would suggest to print a stencil then try to match it with the helmet part. If the stencil is bigger, try to reduce the print page percentage, and do the matching again. If the stencil is smaller, then increase the percentage of the stencil. Do this with every part of the stencils and you'll be fine.
after four attempts with trial and error and the free transform tool in photoshop i got the rear left panel to match up. are things stretched and skewed? a bit. but i figure the scaling for the helmet will make up for that a bit.
This is all really great stuff RF!
Is there any way we can put all of RF's stencils into one thread and sticky them?? I think it would be very beneficial for everyone that way
This is all really great stuff RF!
Is there any way we can put all of RF's stencils into one thread and sticky them?? I think it would be very beneficial for everyone that way