Ok next question, who else has relpicated this on their EE-3? I dont seem to remember seeing any others like this so come on guys show em if you got em
Ok next question, who else has relpicated this on their EE-3? I dont seem to remember seeing any others like this so come on guys show em if you got em
I admit Ive had similar thoughts with regards to getting a clamp to go over my flash tube, its just a matter of finding one that looks the same, in the picture it seems the clamp has two identical 'Protusions' and they certainly appear to be at a 90 degree angle to one another, this may not be the case though so has anyone got any better photos they could share? Thanks for the link Darren
Anytime bro. This thread has me thinking along lines that I had earlier dismissed. The clamp almost appears like it would have a machine screw that would go between the two tabs to draw the clamp into a tight closed position around a pipe or tube.
I am going to break out my Grainger and MacMaster-Carr catalogs to see what I can find.
Yeah that looks good, but, Ive cut out the section of the photo and to me they look like the threads of 2 screws, also I cant make out whether theyre coming out of the bottom of the scope mount itself? :confused
I'm not sure about that, d'you mean the silver 'bands' - I think they look too narrow and not tall enough to be nuts. I was thinking maybe the mount/tube was threaded and the lighter bits are where fresh thread has been revealed by extra tightening at some point. ?
Guy’s I really don’t think these clamps have any sort of nut or screw. IMHO, they are spring loaded, if you look at the rear clamp (the one closest to the trigger), you will notice that the little numbs sticking down are closer together compared to the front. Speculating that the two clamps would be the same size, this would be correct, the numbs would be further apart, because the diameter of the flash tube would be smaller. It’s hard to explain. I wish we could ID these parts once and for all.
I believe that it is a spring clamp. and while I may not be exact to the one I found I believe that there is an older version where the two tabs infact bypassed one another... I will try and sketch something up.
Whilst searching various plumbing supply websites I found this familiar looking item, called an 'Adjustable Band Hanger' looks spookily like a scope mount to me