Looking for 3D file for Jango Arena pack bottom vent cover

Bradleyfett

Active Hunter
Does anyone have a good (accurate) STL or other 3D file for the little cover that goes over the bottom vent of the arena jetpack they are willing to share? Any help is greatly appreciated!

Mark
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top