Fiberglass help!!!

VashDstampede

Well-Known Hunter
TDH PREMIUM MEMBER
I wanted to do a fiberglass casting of my '95 helmet and yesterday I casted it in plaster (took me all day:facepalm)
I did that so that I can make some improvements using the plaster helmet rather than ruining the DP one.
I've have the molding/casting book, read articles, but I wanted to know how others have done so firsthand. I bought gel coat, fiberglass resin, fiberglass cloth, and PVA mold release.
I want to make a 2-part mold using fiberglass, the ears I will do separately, but how do I start?
Will painting the plaster helm and spraying on PVA mold release be enough?
How do I make the partition lines?
How thick does the mold need to be?
This will be my very first attempt as you can tell, so I can use all the help I can get.
Casting in fiberglass is another story too:cry
 
I thought about asking the same advice. There are a lot of members who made their fiberglass helmets and could possibly give advice on their techniques.
 
Thanks for the compliment Super-Mod. Yes I can teach people to make molds, but it requires more explaining than I care to type.
For molding advice, pm me with a phone #, and we'll interact that way. :)
 
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top