crimson
Hunter
I have a Cod, kidney, back, knee and shoulder bells painted by Daz aka boba maker
the knees and shoulder do not matter as they can be used as is (no need to match)
The chest and neck armour is unpainted bobamaker and redkyrodragon
After 2 months i have been trying to match boba maker i have tried and tried and got no where close even ordering the exact same grey daz/ boba maker uses- its close very close but not exact
I cannot match the yellow either The humbrol yellow and greens are very different, i was thinking of using a combination of humbrol enamel and tamiya acrylic- Can this be done ?
The cod and kidney are lower down - plus they are hidden by the girth belt, the back his hidden by the jet pack- would i get away with having two different coloured yellow stippling and greens ?
Here is the overall colours :
The greens here are the humbrol greens as suggested in the humbrol thread :
76 is too light and 76 not the right hue, no matter how much i mix these 1.1 , 2.1 i cant match boba maker
The yellows on paper are humbrol yellows, the yellow on the armour is acylic tamiya
Again Humbrol 99 is too bright and 154 is orange yellow, so no where near BM
Should i bother trying to match these or would a little bit of variation matter ?
the knees and shoulder do not matter as they can be used as is (no need to match)
The chest and neck armour is unpainted bobamaker and redkyrodragon
After 2 months i have been trying to match boba maker i have tried and tried and got no where close even ordering the exact same grey daz/ boba maker uses- its close very close but not exact
I cannot match the yellow either The humbrol yellow and greens are very different, i was thinking of using a combination of humbrol enamel and tamiya acrylic- Can this be done ?
The cod and kidney are lower down - plus they are hidden by the girth belt, the back his hidden by the jet pack- would i get away with having two different coloured yellow stippling and greens ?
Here is the overall colours :
The greens here are the humbrol greens as suggested in the humbrol thread :
76 is too light and 76 not the right hue, no matter how much i mix these 1.1 , 2.1 i cant match boba maker
The yellows on paper are humbrol yellows, the yellow on the armour is acylic tamiya
Again Humbrol 99 is too bright and 154 is orange yellow, so no where near BM
Should i bother trying to match these or would a little bit of variation matter ?
Last edited by a moderator: