Bronze cold cast helmet

Thread starter bryceelischer
Start date Feb 25, 2021

bryceelischer

New Hunter

Feb 25, 2021

I made a mold of a boba fett helmet I 3D printed, and have been making cold casts. But I thought it might be interesting to try something I personally haven’t seen, which is a bronze cold cast boba fett helmet. So I made one !

The antenna and stem and right top ear piece I’m just going to print out and paint. But yeah overall it came out great and I’m pretty happy with it. As a test casting it’s not perfect, unfortunately the bottom right ear the mold was pressed in a bit, which you can see in view from behind. But the next one is gonna be perfect

This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.