Painting the Grant McCune Helmet (GMH)

Was looking around the wiki and found a pic of the back of the helmet I forgot was there...being there arent many out there of the rear section of the PP2
Boba_fett_preproduction2_helmet_back.jpg


oh **** look the two little nubby greeblies no one can figure out are on there!
 
Was looking around the wiki and found a pic of the back of the helmet I forgot was there...being there arent many out there of the rear section of the PP2
Boba_fett_preproduction2_helmet_back.jpg


oh **** look the two little nubby greeblies no one can figure out are on there!

Maybe we should have some replicated for this project?!

yeh one day we'll discover what they are

Not sure if you guys know this but here is a back shot of the PrePro2 "Promo" helmet in the Gallery section of the PP3. (y)

IMGP7142.jpg
 
Well the ROTJ helmet is a "sandy" helmet too :) and the MQ1 area looks very similar...but thats the PP2 the GMH was casted from

Yeah, I get that smarty.
What I meant was the one many consider the ugliest of the helmets.
I always heard of that particular one being called simply the "Sandy Helmet".
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top