tubachris85x
Well-Known Hunter
Ok, well it turned out just as I thought it would. The newer cloth is sooooo much better to work with and I think looks cleaner in the end, over the matt. All the area's, minus the keyslot area is covered and Im just waiting for it to cure and the re-inforcement should be done. I'll try to start the massive bondoing that it will need. I think Im going to spray primer over it too before that, just because Im kinda sick of looking at all the scratches/nastiness on it, as well as clearly point out the problem areas.
Oh yea, Im going to get the gel-coat stuff in a can from west-marine so that I can coat the inside, and keep myself from getting cut up.
You can see one side is the newer cloth, the rest is the matt.
I think my order of operation for this will be:
-wait for the fibeglass to cure
-primer
-cut key slots out
-bondo helmet rim
-get new keyslots/attach and bondo
-fiberglass over keyslot area
-gel-coat
-finish up bondoing spots
-sand and primer
After doing all the above, I think that it should be good to go
-tubachris
Oh yea, Im going to get the gel-coat stuff in a can from west-marine so that I can coat the inside, and keep myself from getting cut up.
You can see one side is the newer cloth, the rest is the matt.
I think my order of operation for this will be:
-wait for the fibeglass to cure
-primer
-cut key slots out
-bondo helmet rim
-get new keyslots/attach and bondo
-fiberglass over keyslot area
-gel-coat
-finish up bondoing spots
-sand and primer
After doing all the above, I think that it should be good to go
-tubachris