That looks cool bro! I got the same end with my Heiland, but I have been thinking to use mine for a lightsaber I am working on. It does have a really good look in your blaster though!
I think I visit whitearmor.net more often than TDH as of late. Boba carries in E-11 in Battlefront II, haha, but the REAL Boba uses an EE-3 though
I always debated about installing innards, but kids always shove their fingers up the barrel. I figured this might put a stop to that, and make it look better in the long run!
I purchased them from shabad about a month ago, and it took me a month how to get them in there without using a hammer and power tools, haha. Turns out, a screwdriver was all that was required
Thats exactly what I did too!!!! Then I took out the small screw that was in the center of the gutts, drilled the hole out bigger, and put a long thin bolt in there. That way i can shove it into my hyperfirm, and its perfectly centered!!! Worked well!!!
Very nice. I like the look too and am doing something very similar.
So I've been noodle'in how the flash tube sits in the blaster. What's the best way to keep the tube in there. My barrel is 100% hollow the entire length. I've got a 3 cell tube (good that I don't have to cut any part of it, since the entire tube is hollow). I've got a few ideas, but am interested on what others do. What did you do Andy?
Very nice. I like the look too and am doing something very similar.
So I've been noodle'in how the flash tube sits in the blaster. What's the best way to keep the tube in there. My barrel is 100% hollow the entire length. I've got a 3 cell tube (good that I don't have to cut any part of it, since the entire tube is hollow). I've got a few ideas, but am interested on what others do. What did you do Andy?
I unscrewed that black bit sticking out of the innards, then I slide the innards in the tube with the glue on the inside of the tube. Then using the holes provided on the tube, I screwed the black bit back into it, to hold the innards in place as the glue dried.
They are right side up, everyone else wears them up side down
ESB Carbonite Chamber, that check out how Boba wears his knees. This is also seen in pre-production art work, they also fit better like this. IMO, how they were meant to be worn.
Silly me my bad your right, Again your gear looks hella cool very detailed and you ware it well i.e. your costume fit look more like the real Boba Fett...Grats