Carefully re-done shoulder bells

mrgr8ness

Well-Known Hunter
I painted my shoulder bells up quite awhile back. I used pumpkin orange base and sunflower yellow misting over top. Then I did the damage, scuffs, weathering, etc. At the time I was very happy with them, but of course, the more time you spend on this forum, the more you hate your stuff compared to others:lol: Anyways, it became quite apparent that my bells looked a bit too orange. I was planning to repaint, but I was really happy with the weathering and damage that took me so long to do, so it pained me to think about redoing it. So, I mixed myself up and really thinned out yellow wash and applied in layers. I was able to save my paintjob and get these bells to look alot better at the same time. Check it out-

Before-
Image184.gif


After-
IMG_0986.jpg
 
That looks awesome! It is actually a great technique to obtain the right color and keep the orange and yellow variation. Did you mask off the battle damage and markings?
 
I applied the wash with a brush. Its actually kind of transparant, so I didn't need to make, just avoid brushing the parts I don't want. I did have to go over the tan around the scratches a bit afterwards but it wasn't a big deal. Yep, I did go heavier with the yellow in some areas to get the variation effect. Weathering is a combination of pastels and really watered down paints(blacks and browns mostly). Bells are made of sintra, but I always round the edges to give it a more fiberglass look.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top