Ok , i try my best but i already masked the silver areas and i did no fotos till now :-(
In fact i have also an lack of time , with an family with two kids , i doupt i have the extra time to make an step by step thread too :cry It could take forever !
And the Boba is not my only project right now by the way ^^ I´m also a little lightsaber nerd , over there on FX-sabers .
With the step-by-step paint I wasn't reffered as to show us a how-to-do-it thread. Just post some images as you do the paint. There's no hurry. Real life is first... Then the others.
I did a deeper analize of the ESB and PP3 armor and I noticed that these two armors (obviously the helmets too) are not the same, but are close enough to confuse an outsider. I'm aware that I did this statement (the ESB/PP3 armors being the same) with ease and I made a big mistake. I'm sorry for the confusion I spread and I already changed the thread title that said ESB/PP3. I will make the necessary changes with the stencils too.
You can use these stencils for the PP3 armor if you don't want a super-accurate one (the scratches on both armors vary slightly in form and the placements are the same). The major change is the Bantha Skull which is the ROTJ type and not the ESB one.
I have been scouring the gallery for shots of the ESB knees and I've only been able to find a few that are at bad angles, too small, or far too grainy to see. I'm not quite sure how to use these templates either as I feel if I were to mask it off and do a layer of Sienna it would look far too high contrast and not anything near the few images I have. Are these mostly meant to be a locator for where to mist in the Sienna with the yellow?