what glue to use when attaching stuff to fiberglass

jangofett76

Active Hunter
What glue do you use when attaching stuff to fiberglass? Thanks. ;)

It seems like the nylon spacers that I made my knee darts are coming apart after trooping at the IU homecoming game this past Saturday.
 
I've had really good luck with epoxy, but make shure its the stuff called Plastic weld. It seems to bond much better than standard 2 part epoxy. I've used this on all my fiberglass armor, and never had a problem. It comes in a dual tube applicator. You just squeeze it out & mix it up. You can get it at any walmart. Hope that helps;)
D
EDIT: BTW, if you are making your knee darts out of spacers, I would glue them together 1st, then drill a hole through the center of the entire knee dart and put a pin, (cutt off bolt or whatever) through the dart w/ epoxy as well. That way you know for shure they aren't coming apart;)
 
Last edited by a moderator:
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top