General Thermal Detinator

B

bpatneaude

Hunter
Just thought i would share this. It was kinda the last thing i wanted to finish for my ROTJ FETT build. This is one of stormriders molds. Enjoy.
cb59ff4f92aeee626f8a8dcf23ec329d.jpg
uploadfromtaptalk1463617813174.jpg

Sent from my SM-N910P
 
Very nicely crud-ed up! I have one of the "hot potato" variety, and I haven't decided whether to weather it or not. Where is the picture in your background from?
 
I made up a couple recently for the same reason .. this was originally done to house the guts of the hot potato HASBRO item as its massive but i then rescaled these to get the 2.5 inch size
I also added a hook so i can connect it to a set of quick release clips i will attach to the utility belt ..
These are not complete and non functional but they look OK.
If any one wants the CAD for this just pm me ... you can have it ...

Al

IMG_6678.gif

IMG_6677.gif

IMG_6676.gif

IMG_6675.gif

IMG_6674.gif

TD2.gif

TD1.gif


- - - Updated - - -

They should look ok for Celebration Europe ... with luck .. As no weapons policy rather than carry a weapon around all day these can hang off the old belt

Al
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top