Test helmet done, Mystery Helmet next...

DW Design

Active Hunter
I finally finished my "test" helmet. It is a Don Post recast that I purchased off of RPF in March. I haven't used a airbrush in about 10 years so it took a while to get use to it. I know that it is not perfect, but I am happy with it. I just wanted to thank Rogue Studios for the color research. I really appreciate all their hard work. Now onto my Mystery Helmet!!!

DP paint looks really good.
On your mystery helmet, It looks like your Range Finder probably an RA replacement. I had purchased one myself and noticed when it was placed on the stock, it was pointing down, alot. What I did to correct this, if you haven't done so already, was to use the dremel and shave away inside of the head where the stock slides in, until it slid on straight. It was a lot of sanding and checking to make sure it was working and I did not overdue it. Goggles, and a mask, a must.
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.