Sculpting the back armour with sintra

Thread starter Twofoot
Start date May 22, 2018

Twofoot

New Hunter

May 22, 2018

Sooooo. I've been making some armour from sintra and omg I wish I'd of used this stuff sooner instead of fibreglass. I've now come to moulding the back piece. There must be a tried and tested method of doing this using sintra. I'm guessing do a little bit at a time. But which part do I start with?? Any help would be much appreciated Thanks

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.