RF attachment


Well-Known Hunter
I have been looking at the gallery pics but I can't tell exactly how the RF is attached to the stalk. I have a Jaster Mereel helmet that I painted up and I just drilled the aluminum stalk and used screws to attach it. I am kinda ok with this method but if there is something better...well, I would rather do that. So my question: Is there a specific way that this should be done or is there a tried and true method of doing this?

This is on an Asok helmet btw.

i use two tiny little screws on all the helmets i've done, like 5/64" or something like that. as far as accuracy goes, i think that's what they did for the movies then ground the heads flush with the rest of the stalk.
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.